The centre notes: hdpe is widely used in car, construction and engineering, consumer goods and electronics industries. It is estimated that hdpe will become the fastest growing part of the mall, with an annual rate of 6.8%.Allied Market Research stated that the global BPD will reach a compound annual addition rate of 4.9% from 2014 to 2020, and the global BPD will reach $162 billion by 2020.In the meantime, polypropylene will continue to occupy the dominant position of blow molding plastic market.Polypropylene in a blow-molding plastic shop in 2014
Hdpe is widely used in cars, construction and engineering, consumer goods and electronics. It is estimated that hdpe will become the fastest growing part of the mall, with an annual rate of 6.8%.
Allied Market Research stated that the global BPD will reach a compound annual addition rate of 4.9% from 2014 to 2020, and the global BPD will reach $162 billion by 2020.In the meantime, polypropylene will continue to occupy the dominant position of blow molding plastic market.In 2014, polypropylene now accounts for 39% of blow-molding stores.
Most of the addition of blow molding plastic shopping malls mainly comes from the demand of the packaging profession for this information, but in addition, several other terminals use occupation such as car, packaging, electronic products and consumer goods, construction and engineering, disposable medical products occupation demand addition, will further promote the addition of blow molding plastic shopping malls.
In addition, from 2014 to 2020, the blow-molding plastic shopping mall will still occupy the dominant position in the packaging industry, which is mainly due to the continuous use of packaging in consumer goods and health care products.
The healthcare category is the fastest addition to the end-use market, as the addition of blood sample analysis colorimetric cups, pregnancy test equipment, needle trocar and medical device components will drive demand.
The statement also pointed out that high initial mold costs and volatile crude oil prices would be adverse factors to prevent the addition of blow-molding plastic stores.